Simplified ASME Thin Wall Pressure Vessel Design Calculation Example – Part 1- Overview

Here I will discuss a thin wall pressure vessel design calculation example according to the ASME section Viii division 1 code.

Thick Wall vs. Thin Walled Pressure Vessel

If the ratio of the inner radius and the wall thickness of the pressure vessel are greater than or equal to 10, then it is called a thin shell or thin walled pressure vessel or else it will be a thick walled one.

Typical Pressure Vessel

 

Now, as the difference between the two basic types of vessel is clear so let’s move towards the actual design problem and it’s  solution.

 Problem statement: Design a vertical thin shell pressure vessel according to the ASME Section 8 Div. 1 for the following input data

Pressure= 75 Pa

Temperature = 90 Degree Centigrade

Volume = 30 cubic meter

Application = for storing high pressure hot water

 

Solution methodology

I will solve the above pressure vessel design problem by using the following steps:

  1. Material selection (will be discussed in this part)
  2. Sizing calculation (refer part-2)
  3. Thickness calculation for the cylindrical shell (refer part-3)
  4. Pressure calculation for the cylindrical shell (refer part-4)
  5. Calculation for hemispherical shell (refer part-5)
  6. Calculations for the nozzles (refer part-6)
  7. Calculations for legs and support (refer part-7)

 

 

Material selection: Typically you have to guess a material and go ahead with the ASME design calculation to check whether the permissible stress values are meeting by the selected material or not, in case it is not meeting the requirement then you have to select a new material and again run the calculation and so on.

For our example, the application requires the storage of high pressure hot water to be used for process industry so I have decided to go ahead with AISI 304 (Chromium-Nickel steel) for the shells. The maximum allowable stress for the AISI 304 is 137 MPa.  I have also decided to select Carbon steel (AISI 1020) for the legs and supports. Maximum allowable stress for AISI 1020 is 350 MPa.

 

The design calculation for this pressure vessel example will be continued to next part (Part-2), where I will do the sizing calculation of the vessel.

Shibashis Ghosh

Hi, I am Shibashis, a blogger by passion and an engineer by profession. I have written most of the articles for mechGuru.com. For more than a decades i am closely associated with the engineering design/manufacturing simulation technologies. I am a self taught code hobbyist, presently in love with Python (Open CV / ML / Data Science /AWS -3000+ lines, 400+ hrs. )

This Post Has 4 Comments

  1. abid

    please fix the broken links for the sections 6 and 7
    thanks,

  2. AYYOUB EL HRACH

    i can’t get parts 6 and 7 please shear with me this parts

    1. Shibashis

      will update it, thanks for pointing it.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.